Difference between revisions of "Visualizing AWP-ODC Output"
From SCECpedia
Jump to navigationJump to search| Line 19: | Line 19: | ||
For this, run the script [http://source.usc.edu/svn/cybershake/import/trunk/AWP-ODC/visualizer/create_timeseries_file.py create_timeseries_file.py]. | For this, run the script [http://source.usc.edu/svn/cybershake/import/trunk/AWP-ODC/visualizer/create_timeseries_file.py create_timeseries_file.py]. | ||
<pre> | <pre> | ||
| − | Usage: . | + | Usage: ./create_timeseries_file.py <X dim in output> <Y dim in output> <grid decimation> <NT in sim> <DT of sim> <NTISKP> <timesteps output per file> <prefix> <output file> |
</pre> | </pre> | ||
Revision as of 18:12, 23 April 2018
This page documents a procedure to visualize AWP-ODC velocity output, using remote Paraview. So far, this procedure has only been tested on Titan using Paraview 4.4.0.
Contents
Configure the simulation
When running the AWP-ODC simulation, make sure it is configured to produce velocity output.
Take note of the following parameters:
- NX, NY, NZ (and NBGX, NEDX, NGBY, NEDY, NGBZ, NEDZ if specified)
- WRITE_STEP
- NSKPX, NSKPY, NSKPZ
- NTISKP
They'll be needed when producing the output.
Create a Paraview XDMF file
Once the simulation is complete, we must create a configuration file which tells Paraview how the velocity data is laid out in memory.
For this, run the script create_timeseries_file.py.
Usage: ./create_timeseries_file.py <X dim in output> <Y dim in output> <grid decimation> <NT in sim> <DT of sim> <NTISKP> <timesteps output per file> <prefix> <output file>
Based on this, a XDMF (XML) file is produced which can serve as input to Paraview.
