Difference between revisions of "CyberShake volume rotation"

From SCECpedia
Jump to navigationJump to search
Line 40: Line 40:
 
|-
 
|-
 
! 100m
 
! 100m
| [[File:erf51_1D_RWG_SGT_test_d0.10.png|thumb|600px]]
+
| [[File:erf51_1D_RWG_SGT_test_d0.10.png|thumb|400px]]
 
|-
 
|-
 
! 200m
 
! 200m
| [[File:erf51_1D_RWG_SGT_test_d0.20.png|thumb|600px]]
+
| [[File:erf51_1D_RWG_SGT_test_d0.20.png|thumb|400px]]
 
|-
 
|-
 
! 500m
 
! 500m
| [[File:erf51_1D_RWG_SGT_test_d0.50.png|thumb|600px]]
+
| [[File:erf51_1D_RWG_SGT_test_d0.50.png|thumb|400px]]
 
|-
 
|-
 
! 1km
 
! 1km
| [[File:erf51_1D_RWG_SGT_test_d1.00.png|thumb|600px]]
+
| [[File:erf51_1D_RWG_SGT_test_d1.00.png|thumb|400px]]
 
|-
 
|-
 
! 2km
 
! 2km
| [[File:erf51_1D_RWG_SGT_test_d2.00.png|thumb|600px]]
+
| [[File:erf51_1D_RWG_SGT_test_d2.00.png|thumb|400px]]
 
|-
 
|-
 
! 5km
 
! 5km
| [[File:erf51_1D_RWG_SGT_test_d5.00.png|thumb|600px]]
+
| [[File:erf51_1D_RWG_SGT_test_d5.00.png|thumb|400px]]
 
|}
 
|}

Revision as of 21:02, 7 January 2020

This page documents the differences we see in results when using volumes with different rotation angles, and the investigation of these differences.

Problem description

When attempting to replicate on Summit results for site USC using ERF 51 (an RSQSim-based ERF) originally obtained on Blue Waters, we ran into some difficulty.

The plot below shows a comparison of RotD values obtained on Summit (Run ID 7054) vs on Blue Waters (Run ID 7014). As you can see, there is a general trend but more scatter than anticipated; the two results should match almost exactly.

Erf51 rotd comparison.png

As a point of comparison, here are the same plots for the USC ERF 36 verification runs:

Erf36 rotd comparison.png

In particular, we identified source 684, rupture 323 as an event to investigate further. At a frequency of 3 seconds, the values obtained on Blue Waters were almost twice as big as those on Summit, 0.23 cm/s2 vs 0.12 cm/s2.

Below are plots comparing the seismograms and the geometric mean PSA values for these events on the two systems. The seismograms start to diverge after about 45 sec, and the geometric mean PSA values show the largest difference at about 3 sec.

Erf51 s684 r323 seis compare.png
Erf51 s684 r323 psa compare.png

Rotation angle

After running a series of tests, we identified that the difference seems to be related to the rotation angle: the smaller values are produced when running with a rotation angle of -55 degrees (what we have used in the past for southern California sites), and the larger values with a rotation of -30 degrees. Neither the site nor this source are near the volume boundaries.

1D test

Rob Graves ran a 1D test in which seismograms were computed about 16 km from the source for rotation angles of 0 and -50 degrees. Below are plots comparing the three components at a variety of depths.

depth seismograms
100m
Erf51 1D RWG SGT test d0.10.png
200m
Erf51 1D RWG SGT test d0.20.png
500m
Erf51 1D RWG SGT test d0.50.png
1km
Erf51 1D RWG SGT test d1.00.png
2km
Erf51 1D RWG SGT test d2.00.png
5km
Erf51 1D RWG SGT test d5.00.png