CME Project

From SCECpedia
Revision as of 23:27, 16 September 2010 by Maechlin (talk | contribs)
Jump to navigationJump to search

CME Project Home Page

This is the SCEC Community Modeling Environment (SCEC/CME or CME) Project Home Page. This home page will be updated to include current and new CME projects and collaboration information. This represents a good starting point for additional information about CME projects.

Fig 1: Two minutes after origin time for the SCEC M8 simulation showing velocity magnitude through local elevation.

SCEC Web Sites

Current Projects

Current Events

SCEC/CME Computational Science Planning Meeting 2010

  • Organizers: T. H. Jordan, P. Maechling
  • Date: Sunday, September 12, 2010 (8:00am – 12:00pm)
  • Location: Hilton Palm Springs Resort, Palm Springs, CA
  • Address: 400 East Tahquitz Canyon Way, Palm Springs, CA,92262-6605
  • Room: Oasis Room III (3rd Floor)

SCEC/CME Meeting Agenda Sept 12, 2010

Time -- Session Subject -- (Session co-Leaders)

Meeting Format: Thomas Jordan gave an introduction to SCEC4 computational science program. Then, the meeting was organized around four main discussions areas:

  1. SCEC CVM development and Inversion-based CVM Improvements
  2. Stress Evolution and Dynamic Rupture Modeling
  3. Higher Frequency Ground Motion Modeling
  4. UCERF3.0, Time dependent PSHA, Eq Response Modeling.

Each session had two discussion co-leaders. Each session co-leader presented about 10 minutes of material describing their recommendations for CME computational science research during SCEC4 which generated general discussions on how to organize the CME collaborative computational science research.


Meeting Participation Information

  • Date: Sunday, September 12, 2010 (8:00am – 12:00pm)
  • Location: Oasis Room, Hilton Palm Springs Resort, Palm Springs, CA

CME-related 2010 Meeting Posters:

CME-related web sites

SCEC Computer Science Collaborative Organizations and Resource Providers

Related Research Areas